EX2 WIRING WITH SWITCH Join both positive red leads from the driving lights to one cable size listed in the below table by crimping the ends together. Terminate the cable to one end of the fuse holder and other end to the positive terminal of the battery.. EX2 WIRING WITH SWITCH Join both positive red leads from the driving lights to one cable size listed in the below table by crimping the ends together. Terminate the cable to one end of the fuse holder and other end to the positive terminal of the battery.
5. Identify the switch wiring (red wire with a brown wire inside the sleeve). Locate a grommet through the firewall and pass the switch wire through the pierced grommet to the switch location. 6. To connect the switch wire inside the vehicle, strip off the end of the insulation of the wires then crimp a terminal to each end.. the end of the insulation of the wires then crimp a terminal to each end. Note: An addition Connect the high beam wire (brown): on the back of the head light or at the high beam switch (R Fit the switch wire (brown) using a suitable connector type.