You can wire the positives (Led+ in your diagram) to LED5 and LED 6 pads. The negatives (Led-) goes to GND. Note that LED5 and LED6 output 3.3V and 20mA so calculate the LED resistors based on that.. BLUE LED - Flight controller status light which is controlled by the flight controller firmware. Orange LED - LED Control Mode Indicator. It indicates the 4 sets of LEDs connected to LED1-LED4 connectors on the bottom side are controlled by Betaflight firmware(BF_LED mode) or the Bluetooth Chip(SB_LED mode).
It indicates the 4 sets of LEDs connected to LED1-LED4 connectors on the bottom side are controlled by Betaflight firmware(BF_LED mode) or the Bluetooth Chip(SB_LED mode).. Speedy Bee F4 V3/V4 above image and some content courtesy of the speedybee.com Specifications Processor and Sensors STM32F405 ARM microcontroller V3:BMI270 IMU, V4:ICM42688 (Gyro and Accelerometers) V3:SPL06, V4:DPS310 Barometer AT7456E OSD Interfaces 9x PWM outputs (PWM9 for Neopixel LED) 1x RC input (PWM/PPM, SBUS) 6x serial port inputs (including RC input listed above) 1x I2C for external.