The charger doesn't have built in rear access for a hardwired installation. So either the 6/3 cable will come out the bottom and then go into the wall (ugly) or I cut a hole in the back. Well, I plan to cut a hole in the back with a hole drill bit and would like advice. If I move the now-unused strain relief from the bottom to the added hole in the back and install the charger inside a garage.. The Emporia EV Charger is capable of charge a vehicle at 40A on a 50A breaker (NEMA 14-50) or 48A on a 60A+ breaker (hardwired). The Emporia Energy app and a Wi-Fi connection are required to take advantage of its smart functions, including: changing the charging rate, integrating with Emporia products and other smart devices, and energy.
The Emporia EV Charger is intended to be installed in stationary, grid-tied power systems. Do not use the Emporia EV Charger with back-up generators. Do not use the Emporia EV Charger in any manner other than specified in this installation guide. Do not attempt to disassemble or repair any of the components of the Emporia EV Charger.. The Emporia Energy Level 2 EVSE EV Charger offers two installation methods: a pre-installed NEMA 14-50P plug or a pre-installed hardwire whip. Each option provides different benefits based on your needs and electrical setup.